Ok I tried changing the model, I am now using a Static General step.
However there still seems to be a major problem. In this model I am pushing the endplate into the rigid body. I am applying force all along the endplate closest to the rigid body and not the plate at the end of the beam.
I've...
That is what I have been trying to do, however after I create the properties and wish to create the interaction I get this message from trying to create a contact. 'Pressure Penetration interaction can only be created in Planar and Axisymmetric models'.
Does this mean I'll have to create the...
Hi, I'm modelling a square steel beam connected to an end palte being twisted and pushed into a rigid surface.
I've modelled it in shell as my beam is hollow and will be too thin for proper analysis. I'm using a static linear perturbation step for the analysis and I'm not sure how to model the...
Thanks for the help.
I now know how to model this properly (I tried a different model which was just a solid square block and thicker endplate), however I learned from another site that my meshing isn't fine enough as I would need three cubes in thickness in the beam in order to properly...
Hi, I tried to do what you told me, however this message came up instead when I was trying to run the job.
"Interaction property contact surface specifies a contact damping type of step type, which is not available in Abaqus/Standard analysis.
The input file was not generated, and the job was...
This is the picture of the contact menu
Thanks for any help providedhttp://files.engineering.com/getfile.aspx?folder=e50044b1-d4ea-47a2-9375-77f7e7b36e20&file=menus.png
Hi, I've asked this question several times to no avail and I still have to get a working model.
Basically I wish to model a steel beam to column connection that is under torsion. In the picture provided the flanges at the beam are to simulate torsion and the beam is connected to and endplate...
I'm ran the simulation again and it's been over an hour. This is the message that I have gotten from it.
Does anyone know what I may be doing wrong. It just isn't analysing the job that I created http://files.engineering.com/getfile.aspx?folder=9b3a323f-079a-4f7b-9a96-afd585683cf1&file=Untitled.png
The main problem I am facing in my model, is that when running the model the analysis can take over 30 minutes and there is a warning that says "There are 2 unconnected regions in the model."
This is the model that I have created. There is a UDL on the beam and the endplate is fixed at the...
The endplate and beam are in union and the flanges at the square beam are to apply torsion. The endplate is fixed at the edges and can warp in any direction to the (Z)axis. What I really want to do now is to stop the endplate warping into the back but allowing it to warp in the direction of the...
I tried what you said about the displacement boundary conditions, however the endplate is now not warping at all. I wanted it to be able to warp towards the beam while not being able to do so towards where the column is supposed to be located.
