Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by K. Adam

  1. K. Adam

    Hot oil Flashpoint

    Thanks for your input, appreciated!
  2. K. Adam

    Hot oil Flashpoint

    Thanks Gentlemen for your feed back; well appreciated.
  3. K. Adam

    Hot oil Flashpoint

    An insulated flange was smoking and while removing the insulation material to investigate a flash fire occurred as the insulation material found to be soaked with hot oil due to leaking flange.
  4. K. Adam

    Hot oil Flashpoint

    thanks for your reply and apologize for being late in my reply.
  5. K. Adam

    Hot oil Flashpoint

    Good day Gents, We are using a thermal oil as heating source to heat up our HC products and Glycol system. A flash fire occurred while removing an insulation material to investigate source of smoke in the flange area. As part of investigation, oil sample was collected, analyzed and the result...
  6. K. Adam

    Blockage Of Chlorine Injection Lines on Sea water Lift Pump

    Dear all, I do respect and appreciate all your feed back. I do apologize as I'm in an emergency situation and I shall continue the discussion with you gentlemen next week as I'm out of the office in an emergency trip. Thanks and again I well appreciate all your answers.
  7. K. Adam

    Blockage Of Chlorine Injection Lines on Sea water Lift Pump

    Good day Gents, We are suffering from frequent blockage in the chlorine injection lines to our seawater lift pumps in offshore and the main challenge for us is deblocking of injection lines at the subservice area which is quite difficult as we have to pull the pump out of the casing in order to...
  8. K. Adam

    TEG Pumps having high discharge temperature

    Well noted. Thanks for your kind feed back.
  9. K. Adam

    TEG Pumps having high discharge temperature

    Regarding the second possible reason you mentioned in your reply "Recycling of TEG due to broken/worn out piston", I just would like to inform you that we have steady flow with minor fluctuation but having knocking sound in pump skid.
  10. K. Adam

    TEG Pumps having high discharge temperature

    Thanks for your input and well appreciated...
  11. K. Adam

    TEG Pumps having high discharge temperature

    Dear Gents, Actually we are suffering from frequent failure in our Glycol pump discharge pulsation dampener. as part of investigation we noticed that the pump's NPSH is quite low due to suspected blockage in the upstream exchanger tube bundle. Can any one explain to me the possible root cause of...
See more

Part and Inventory Search

Back
Top