Hello gr2vessels,
first of all you should aware that Halim gala design is based on ASME and TEMA code only. no other procedure involved in his design.
You mistaken me that i am designing completely based on Halim galala design...its absolutely not, its just for understanding the code.
Net is...
thank you for your kind reply..i checked whether it is an equation or a constant after your suggestion...i found that it is not equation.....
i need some information regarding gasket dimensions...ASME code says nothing about the gasket dimensions like ,width(N),outside dia, inside dia and no of...
Dear All,
in page no:37 of 136 in Design calculations of heat exchanger in Halim galala book the ouside diameter of gasket is caculated by using the correlation (B.C.D-d)-2*13.
in that i didn't understand the number 2*13 ?
even if i consider it as a product of 2 & 13 the result doesn't make any...
hi..
i am designing a external pressure vessel for desalination process.i want to calculate wind load acting on the vessel and load acting on the support.the details are given below..
1. from bottom cone height:1.2m
2. above the cone, cylindrical portion height:3m
3. the vessel is to be...
Thank you stephen...
Now i got one way to solve the problem...i got some value for gusset thickness by assuming a value in rankines formulae..after that i checked back the gusset thickness with the rankines formulae..this value should not exceed the allowable stress for material given in ASME...
Thank You very much..for your kind reply...
now i got another doubt from your answer...before calculating the gusset thickness we need to calculate allowable compressive stress to arrive the thickness..may i know how come it possible to calculate gusset thickness without allowable compressive...
hello.
in bednar page no 157 in rankines formula the "r" has to be calculated. in page no 156 the "r" value is given as 0.289*0.625 under the fig no.5.9.
any body can you please tell me what are those values(0.289 and 0.625)...normally we will use r=sqrt(I/A)