whymejc,
This is a general formula that you can use sorry diagram would not paste.
BEND ALLOWANCE (BA):
1)90° Bend: L= (t/3+r1) 1.5708 Note: General rule for r1 less than or = to (t) use t/3, for r1 greater than or= to (t) use t/2.
2)Less Than 90° Bend: L= (t/3+r1) (.0175x n°) Note...
Does any one know where to find a chart online with draw reduction percentages for various materials i.e. steel, aluminum, stainless etc.
Regards, J. Yatteau
Does any one know where to find a chart online with draw reduction percentages for various materials i.e. steel, aluminum, stainless etc.
Regards, J. Yatteau
Does any one know where to find a chart online with draw reduction percentages for various materials i.e. steel, aluminum, stainless etc.
Regards, J. Yatteau
Does any one know where to find a chart online with draw reduction percentages for various materials i.e. steel, aluminum, stainless etc.
Regards, J. Yatteau
Alek
I do not know of any particular software other than I thought PRO-E had a sheet metal package. Lets see if I can help nonetheless. If I understand your question you are encountering material springback a common problem when wiping. The severity dependant on many variables in sheet metal...
