Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by JWS522944

  1. JWS522944

    entering mm in inch drawing AutoCad or DraftSight

    This is in response to thread1480-335482. This is what I used to use in AutoCad and it should work in DraftSight. With the drawing set to inches to enter a mm dimension just use a fraction with a decimal shift. Example 10mm would be the fraction 100/254 since you can't enter 10/25.4 500mm...

Part and Inventory Search

Back
Top