Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by JVD2
-
Cam groove Design
Hi all, With trying to 3D model a Cam profile from an old 2D drawing i'm stuggeling with the dimensions of the Radius of a profile. See picture attached. I can't seem to figure out what way these R should relate? It is a constant velocity profile for a follower of 22mm. I can't seem to get an...- JVD2
- Thread
- Replies: 3
- Forum: Mechanical engineering general discussion
