Recent content by jujumoi

Hello, I always have used Ansys Classic, however, I had to change to workbench. I can run most of the analysis that I was used to run on Ansys Classic, the electrostactic analysis however, is not shown on environmental map. I could find only the Magnetostatics option (that's the closest...

Thanks for the replys. In fact I thought that split the current in two IGBT`s was better, even for circuit protections. In fact I need this High current values for a short period of time (Time enough to heat up some Plugs). Thanks for your help!

Thanks ScottyUK, I haven't considered any IGBT yet, but it sounds a very good choice. 120Amps is defintely a high current, I don`t know if the package can handle that top cuerrent for many cycles. I think the most important thing that I should consider in this case is the heat dissipation, since...

Does anyone know a MOSFET that can handle High currents (up to 120Amps)?

11) Will ANSYS 11.0 work with Windows Vista? No, V11 will not work with Windows Vista. A service pack is expected which will update V11 to be able to work with Vista. No date has been provided for when the SP is expected. Source...

Thak you very much Doug, I was killing myself here, I though I`ve already defined the target elements on the active CS, and I couldn`t find this little simple detail. Thanks again!

Hello, I'am having some troubles trying to set up a 3D contact analysis of a cylinder and an arc. The contact is not occuring, the contact volume is not interacting with target elements. I think Iam probably not constraining the model correctly. The input file is listed below, if anyone can...

I just finished an APDL code, but it was taking too long to rebuild the nodal model: !maximum node number *get,n_max,node,,num,maxd !temporary array list_tmp= *dim,list_tmp,array,n_max,11 !status of selection (masking vector) *vget,list_tmp(1,1),node,,nsel !filling array with...

I wonder if it is possible to export the meshed deformed shape resulted from a static analysis (i.e. a displacement analysis) so it can be used as a model for a new static analysis. Note that this is different from a transient analysis. Thanks

Nevermind, It was a problem with my Video Card. It's all ok now. Thanks for your attention. Juliano

Good afternoon, I'm trying to plot the PSD input curve (from a PSD table) using PSDGRAPH command. The problem is that the graph displayed doesn't show any data (dot's or solid lines). I'm using as an example the following commands: PSDFRQ,1, ,100,400,1200,2500, PSDVAL,1,.02,.05,.05,.01...

Goodafternoon, I'm trying to develop e model to extract temperature and strees values by simulating a pulsed laser in a volume. I was wondering if there is a way to remove nodes (the nodes that achieve TEMP values over the Material Melting Point ) from the model at each substep (I don´t think...

Thank you!

Is there anyway to use an incremented variable on the name of a saved image file with APDL? For example, I have a simple loop with i_ as being the increment variable. i_=1 *DO,i_,1,180,1 /IMAGE,SAVE,i_,bmp /ANG,1,-1,YS,1 /REP,FAST i_=i_+1 *ENDDO However, everytime the saved file is i_...

Thank you alot! It really worked for me and now I can continue with my work. Thanks again! Best Regards!