Hello everybody,
somebody knows the material X-63?
I suppose it is an very old API designation (API 5L X-63 Gr.B)
Am I right? In which standard version can I find it?
Best regards
juan
I was asking almost the same question in the "material Engineering other topics" forum, and the answer I got were quite surprising, something like, "you want to replace engineers by software" !!!
[evil]
pencil is still useful for some revamping. Anyway having learnt with them is more than useful.
I am not looking for a stress analysis program but more a wall thickness and branch (under inner pressure) calculation such as Probad from IBM.
A big advantage is the material database update, which...
not at all. We cannot replace the calculation engineer.
The software shall simplify the work.
For example we can proceed stress analysis of piping per hand but there is also software for that. Again no programm will replace the analysis of an engineer.
Hello everybody,
I am looking for a software for sizing of pipes, branches and fittings according to codes B31.3, EN and Codeti.
It should be easy to handle and not too expensive.
Any suggestions?
Hello everybody,
I do not know if this forum is the good on e for my question, but I try.
I am looking for a software for material management which is quite modern, with connections with 3D CAD Programs.
Any ideas?
