Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by JSNYDERCMC

  1. JSNYDERCMC

    Hole Tolerance Question

    To clarify - The bushing design was just changed. We are switching to a plastic bushing with a slit in it, so it can fit a range holes, it has a .035" slit in the side and now has a .315" OD with and ID of .258 +/-.005 on both OD and ID. With that said, it will fit down to a .305 hole if my...
  2. JSNYDERCMC

    Hole Tolerance Question

    Hey, My question was not using worst case, I figured that out. I was wondering if I was using the RSS, more specifically if it was okay to take off from the outside to the center and then just double everything to get the entire hole tol. Thanks, J
  3. JSNYDERCMC

    Hole Tolerance Question

    Hello, I am trying to perform a tolerance stack up on a small assy. I have: Block w/ Hole ID - 0.309 +/- 0.002 Bushing OD - 0.307 +/- 0.005 Bushing ID - 0.250 +/- 0.005 Pin OD - 0.244 +/- 0.002 I want to put the bushing into the hole and put the pin into that. I have...

Part and Inventory Search

Back
Top