Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by JrEngJP

  1. JrEngJP

    bushing/shaft chart

    Unclesyd, Thanks for the links. Unfortunitely the calculator wont let me specify the cylinder I need. 12" ID X 164" Stroke, 345 bar. There isn't a shock load and very little rotation (no more than 3 degree's). We've used S7 steel pins for some time on our cylinders and I'm just trying to figure...
  2. JrEngJP

    bushing/shaft chart

    I'm specifying a bushing for a 6" dia x 11.75" S7 steel pin that will take a 300 ton load (mounted on the end of a large hydraulic cylinder) and I was wondering if anyone out there has come across a standardize chart for bushing types with varying loads. The machinist handbook only goes to 1"...
See more

Part and Inventory Search

Back
Top Bottom