Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by JPArnett
-
Automate Data Collection
Thank you so much!! This was my first day using NX journals and I cant believe I actually did it. The thread you shared was exactly what I needed. I made a small changes. Each iteration now prints all the named expressions on a single line. Option Strict Off Imports System Imports NXOpen...- JPArnett
- Post #3
- Forum: Siemens: UG/NX
-
Automate Data Collection
I would like to automate the task of calculating the mass and center of gravity for a model while varying a dimension over a range of values. Where do I start with this task and what tools should I use? I have an expression driven model with measurement expressions for the mass and center of...- JPArnett
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
