Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by josephYETI
-
ASME Section VIII Pressure Vessel Made from Piping Components
Marty, Thanks, that's an excellent point. I was planning to do it inline but that does make sense from both a code and manufacturing standpoint to use a 8x4 conc reducer.- josephYETI
- Post #3
- Forum: ASME (mechanical) Code Issues
-
ASME Section VIII Pressure Vessel Made from Piping Components
I've got a code issue at work with regards to making a condensate drain tank. The tank is made out of 2 pipe caps and a 1-1/2' section of pipe, all 8" nominal diameter, schedule 40, with 1" NPT half couplings as inlets and outlets, and a 4" ANSI 150# pipe flange on top that's met by a blind...- josephYETI
- Thread
- Replies: 4
- Forum: ASME (mechanical) Code Issues
