Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by jonrya91
-
Questions regarding measurement of Roundness
My company is new to a tight tolerance ground bar. It's ISO H8 which is +0/-.0013" diameter, .00065" roundness. These bars are roughly 10-12 feet long. I understand that the most effective way to do this is with a roundness tester. (Air bearing, stylus which plots the profile)...- jonrya91
- Thread
- Replies: 1
- Forum: QC, Inspection & Testing engineering
