Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Jonagorn

  1. Jonagorn

    Model to drafting unwanted lines showing up

    Hello, after modelling a part and then going on to draft it, I noticed that some lines behind surfaces were showing up for some reason. Also, at the edges where I chamfered them, you can still see the original edge as well as the new. Any help would be much appreciated. Thank you.
See more

Part and Inventory Search

Back
Top