Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by johndoyle
-
shock tool steel
Building hydraulic ironworker, been advised best material for shear blade would be A7 shock tool steel, hardened right through then tempered. If this is correct, what procedures/processes for hardening and tempering (low tech) would you advise we use?- johndoyle
- Thread
- Replies: 1
- Forum: Steel and Stainless engineering
