Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by joebee78

  1. joebee78

    InRoads Bridge

    Does anyone know if it's possible to use *.ics files to establish bridge geometry (edges of slabs, centerlines of girders, centerline of bearings, etc.) and then use InRoads Bridge to extrude the model? If so, is there any documentation on how one would go about doing this? Thank you
See more

Part and Inventory Search

Back
Top