Recent content by jmuriarte

Hello: I have some questions about Hi lock and Lock bolt fasteners. I know a few things about them, both of them are composed by a pin and a collar, the Hi lock takes tension by the torque of the collar and the lock bolt takes the tension on the pin by the riveting machine, but ... Which is...

Thank you very much for the information . Perhaps its a stupid question but, any of these books treats detail design themes?

Hi solid7: I tryed to project a geometrical set, like you explain in your post ,but I work with release 16. I am trying to do this between to diferent geometrical sets but I cant.

Hello everybody: Could you recommend me a good book of aircraft structures design?. I am an Industrial designer and I would like to learn about this kind of structures. Thank you very much.

Thank you very much, I will try it.

Hello: Some body knows how can I create a multiselection that updates depending on new geometry created. For example: I want to project on a plane all geometry created in a geometrical set. Thank you very much.

Hello: I have a problem with tooling:Along the updating proccess of the tooling, I have a curve, paralell from an other one that some times can be in error.In these cases the curve must be deactivated. I tryed knowledge advisor Reactions, "when update happens something(parameter) changes, but...

I have realized that the error curves are "Unresolved" curves. And in rule editor of r16,I can see that in the "language browser" there is an attribute of a curve called "error". How can I extract these attribute to a parameter??

yes I have KWA.

Hello every body: Is there any way to deactivate a curve when it is in error, For example when I do an offset of a circle to the inner side wtih an offset value biger than the radious. Could it be done using , rules, reactions, loops???. Thank you.

I get it , thank you very much.

First thanks for your posts. I will try to explain better what I´m trying. I want create a ounter contour of a part from a datum contour. It must be done with an automatic contour(offset from the datum..) or if I activate or deactivate a parameter from a manual sketch. I think it could be...

Hello: Is there any way to change the contour of a pad using parameters? With the pad allready created use a parameter (string , boolean...) to say which is the correct contour(A or B). Thanks

Hello: How can I check fast(faster than "insert-operation-invert") the direction of curves and surfaces? Is there any property that could be checked? I need it when I replace published surfaces and contours for solid construction. thanks

Hello: How can I select surfaces which are continuous in tangency? The same you do when we do G0 propagate in Joins, but without joining them.