I don't think you can import that old app into PB32. The direct replacement for the 2711-KC1 is a PV 1000e, which uses a different flavor of PanelBuilder software. RA has a migration program called "Step Forward" where you can trade in your old unit and get a PV1000e, the new software, an import...
malifluous (Agricultural),
Hey, Just for my 2 cents. I have worked with controlling christmas lights and it's hard to get PLC's to handle the current required to turn lights on and off.
Most PLC relay contacts are rated up to 3A, but the real problem is the Common amperage. Some PLC's contacts...
Hey NickFury,
I draw this type of drawing all the time. Here's my take on converting the drawing.
I labeled the terminals from right to left.
This is a very typical start stop circuit. I imagine the CR's control something else once this is installed.
Good luck...
Hey Everyone,
I would like suggestions on the best way to design a pnuematic circuit for a 3 -position cylinder. The cylinder is made by TRD/Bimba. Has 4 ports - 2 for each piston.
The cylinder is installed vertically with the weight of the tooling (Vacuum Puller)pulling down. In this...
