Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jj_550

  1. jj_550

    Heat exchanger manifold design

    Thanks for your response
  2. jj_550

    Heat exchanger manifold design

    Hi Mike, No, the Hx is not stamped, the idea is to verify with a standard if the collector meets any design standard. It is made of Stainless Steel, and it is located in an industry. Regards JuanJosé
  3. jj_550

    Heat exchanger manifold design

    Hello, I have a heat exchanger, for which I need to recalculate the manifold which is square cross section. For the calculation I must find a norm or standard (ASME, ASHRAE TEMA) to support the calculation memory. Please do you know where I can find this norm or standard? Thaks
  4. jj_550

    Heat exchanger manifold design

    Hello, I have a heat exchanger, for which I need to recalculate the manifold which is square cross section. For the calculation I must find a norm or standard (ASME, ASHRAE TEMA) to support the calculation memory. Please do you know where I can find this norm or standard?
See more

Part and Inventory Search

Back
Top