Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Jinder

  1. Jinder

    AXIAL FAN FLOW

    I worked out the mass flow rate by: m= rho*V*A Rho = 1.164030723 Area = 0.035210185 Delta P = 0.5*Rho*V^2 V = (Delta P/0.5*Rho)^0.5 Rad @ mid height = 0.09625 At the moment all it is, is a fan, it need to be used as a rig eventually. I need to extend the flow, and fit in an orifice...
  2. Jinder

    POOR EFFICIENCY FAN 2

    I have an axial fan rig that has a new rotor. I have tested it and the efficiency of the new rotor is only about 30% max. My question is, what are the reasons for poor efficiency, why is the new rotor not very good? It is run at 2000rpm. Could some-one please also put me into the right...
  3. Jinder

    POOR EFFICIENCY FAN

    I have an axial fan rig that has a new rotor and stator design. I have tested it and the efficiency of the new rotor is only about 30% max when it should be about 80% My question is, what are the reasons for poor efficiency, why is the new rotor not very good? I t is run at 2000rpm. Could...
  4. Jinder

    POOR EFFICIENCY FAN

    I have an axial fan rig that has a new rotor and stator design. I have tested it and the efficiency of the new rotor is only about 30% max when it should be about 80% My question is, what are the reasons for poor efficiency, why is the new rotor not very good? I t is run at 2000rpm. Could...
  5. Jinder

    I am trying to set up an axial fan

    I am trying to set up an axial fan rig. I have calculated the max. mass flow through it, and now need to find out what size ORIFICE PLATE should be used. I have a copy of BS 1042, but this is since 1943, far too old with imperial units not metric. This has examples of how to calculate the...
  6. Jinder

    AXIAL FAN FLOW

    I am trying to set up an axial fan rig. I have calculated the max. mass flow through it, and now need to find out what size ORIFICE PLATE should be used. I have a copy of BS 1042, but this is since 1943, far too old with imperial units not metric. This has examples of how to calculate the...
  7. Jinder

    AXIAL FAN RIG

    I am trying to set up an axial fan rig. I have calculated the max. mass flow through it, and now need to find out what size ORIFICE PLATE should be used. I have a copy of BS 1042, but this is since 1943, far too old with imperial units not metric. This has examples of how to calculate the...
See more

Part and Inventory Search

Back
Top