Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by JimB006
-
converting 1/2" drill motor to sprocket system
The drill motor is rated at 450rpm, 4.5amps. I thought a chain and spocket will eliminate any slippage. To measure the torque I will have to lower the tower and measure the torque with a torque wrench on the gear winch. But I will have to wait until the spring for the weather to change. I...- JimB006
- Post #3
- Forum: Gear and Pulley engineering
-
converting 1/2" drill motor to sprocket system
I have a 1/2" 450RPM 4.5amp drill motor that I use to raise and lower my antenna tower. The drill motor drive a 50:1 gear winch. I want to make a sprocket system using a 115volt frame motor. Any suggestions on motor size and sprocket size would be appreciated. The torque required, which I...- JimB006
- Thread
- Replies: 3
- Forum: Gear and Pulley engineering
