Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by JibJabCory
-
Difficult perpendicularity measurement on a small part
I was hoping to get some help measuring the perpendicularity of the end faces relative to the OD of a 1 mm rod. The tolerance is 2.0 mrad and I would also like to sort out the ones that are below 1mrad. The tight tolerance is required for the optical performance of my design. ROD: 1mm diameter...- JibJabCory
- Thread
- Replies: 1
- Forum: QC, Inspection & Testing engineering
