Thanks for your response. I am more concerned with pinning down the irritation cause to the rubber bag(or not). What will happen when the iron oxide coating fails, same with oxidation? Will this cause oxidation?
I have no circuit design experience and have a manufacturing/mechanical background, so this question may sound stupid. Is it common practice(or done at all) to design a board so that two components are shorted(on purpose)? Or is this most definitely a manufacturing error?
The components on the...
I have some rubber in a system where I noticed a yellow color on the rubber inside and also on place surrounding it. I noticed this after a long period of time(it was not there when the system was first made). My research indicates this may be sulfur. The rubber I have will be used in an...
I am having a problem with this pressure sensor.
http://cache.freescale.com/files/sensors/doc/data_sheet/MPXH6300A.pdf?pspll=1
The sensor is glued into a hole that goes to the gas under test. The gas is leaking however so I am looking for a threaded sensor as similiar as possible. I am not an...
We have a brightsilver powdercoat that we are using. With this paint, we have been having issues that with even light handlingg(think rubbing your thumb with the same force that will turn on a light switch) it will develop a distinct black stain on the powdercoat that cannot be removed. Dooes...
Thanks for the help everybody. I do not think the reason is a health issue since the same supplier also cuts the class with a milling machine.
I will have to get back with more details.
I need to grind about(.015-.030) a quarter inch from the bottom of a leaded glass sheet so it can fit into a sliding track to make the glass thinner. I was surprised when the I called the guy who does some other processing steps tell me he could not do this.
Is there some reason why this is a...
I'm looking for a fixed mount expandable mandrel. I have found a few of what I was looking for however none have been long enough. I need the blades(or expandable part, whatever it is) to be at least 1.5" inches long preferably 3-4 inches long.
I have found plenty of mandrels where you press...
To swall
All over
To Btruehood
I have tried cast and that works fine(some cracking but it retains it structual integrity). However this application is in production, so switching to cast will be very expensive. I've tried getting rid of the flame treatment or using a cooler gun but that...
I am machining a tube of acrylic. I am noticing that afterwords when putting the acrylic into contact with solvents(Alcohol in particular), is cracking at a very rapid rate. However when I place the stock material in contact with this same solvent it does not crack. What can I vary within the...
