Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jbro2

  1. jbro2

    Looking for a solution in NZ for concrete in high heat, steam and low ph.

    Thanks Pierreick. We are a Sika and Fosroc certified installers as well multiple other brands. We also do a lot with custom concrete mixes. I am looking for other solutions that could possibly be an option for future projects also we have clients that have a few of these environments that...
  2. jbro2

    Looking for a solution in NZ for concrete in high heat, steam and low ph.

    Hi all I am curious if there are any coating, mortars, or grouts that can be used in a high heat ( up to 300 C ) which receives steam and low ph from a blow off tank. Can any one suggest a repair product that would work in this environment. This is in NZ so some products are not available here.
  3. jbro2

    Has any one worked with Zylon?

    Well thank you all for the wealth of information. I was looking into the these exotic material only because of the appeal of it being just that. I had a hunch it was above and beyond what was needed but the only way to learn about things some times is it to try it. I really appreciate the time...
  4. jbro2

    Has any one worked with Zylon?

    Thanks Moudoc sounds like this will be a little outside my budget at this time. Autoclave is not going to be an option at this time either. But thank you for the information thats what these forums are great for. I think that the tooling cost will be to high for a product that is possibly only...
  5. jbro2

    Has any one worked with Zylon?

    Just read up quick on PEEK, not to familar with it but very interested. How would i go about working with this product is there any specific tools that i would need? I have vacuum equip. and i am currently working on an oven project that has taken a back seat for a little bit. Is PEEK a product...
  6. jbro2

    Has any one worked with Zylon?

    Moudoc Thank you for being the one and only person from multiple forums to give me an answer at all, never mind the knowledge you have on this product. I will be looking into the Bismaleimide, for the hi temp areas. Does that product require a post cure cycle or does it cure with Hi temp...
  7. jbro2

    Has any one worked with Zylon?

    Just trying to get some more information regarding Zylon or zylon/carbon hybrid. I am looking to see if this fabric is worth working with and what the drapability, what resin type works best for it. I have been reading that this has much better abrashion resistance and heat resistance than...
See more

Part and Inventory Search

Back
Top