Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jbag

  1. jbag

    Galvanised Steel Pipe Internal Roughness?

    Thanks Ione and Katmar. Kind regards
  2. jbag

    Galvanised Steel Pipe Internal Roughness?

    I perform calculations on a regular basis for water and compressed air supply to underground coal mines. The standard piping used for these services is victaulic galvanised steel pipe and as a basis for the calculations we have tried to determine a suitable internal surface roughness for this...
  3. jbag

    Orifice Plate Sizing

    Thanks all, jbag
  4. jbag

    Orifice Plate Sizing

    Hi, Does anyone know of an equation to calculate the diameter of an orifice in a thin-edged orifice plate for a particular K-value (loss coefficient)? In particular, for water or slurry duties. Thanks in advance, jbag
See more

Part and Inventory Search

Back
Top Bottom