Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Jay T

  1. Jay T

    Backhoe Swing Frame force calculation

    Based on the details of digging force, hydraulic cylinders, I would like to calculate forces on the swing frame of a backhoe. Following are the details as per attached images, BC1 - Reach diagram for the backhoe BC2 - Hydraulic specs and swing details of backhoe BC3 - Force details, hydraulic...
  2. Jay T

    [img https://res.cloudinary.com/eng

    Sorry for such a vague post without any more information. So I have attached an image with the information. For me, I am given the task to decide the material for the PIN A and PIN B as shown in the picture. Pin A - 1" Dia X 6" L Pin B - 1" Dia X 5-5/8" L These Pins are Cylinder Pins which...
  3. Jay T

    [img https://res.cloudinary.com/eng

    I want to spec top and bottom cylinder mt pins for one of our design weldments. I have no idea how to approach it
  4. Jay T

    Carbon steel tubes standard

    We use ANSI
  5. Jay T

    Carbon steel tubes standard

    Hi I am looking for more understanding on some standards. For drawings of steel plates, we follow G40.21-44W. Does this apply to steel tubes too? or it is different?
See more

Part and Inventory Search

Back
Top