Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by jaulino
-
HELP! Iteration repeting itself
Hello all, I'm trying to simulate an ejected molded component. I used helius to map the material and used the automatic stabilization to keep eliminate the rigid body movement. First, i tried with a linear material and everything was fine. Then i mapped the experimental data, and run the...- jaulino
- Thread
- Replies: 1
- Forum: DASSAULT: ABAQUS FEA Solver
-
Import inp. file - Abaqus not responding
Mustaine3, thanks for your reply. I'm finishing my master thesis and i need to do a structural analysys from a part injected in moldflow. I'm doing a direct transfer data (moldflow to abaqus) and a transfer data using digimat. I've been struggling with the direct transfer. I guess i will try...- jaulino
- Post #3
- Forum: DASSAULT: ABAQUS FEA Solver
-
Import inp. file - Abaqus not responding
Hello all, I ran the interface between abaqus and moldflow to generate an "inp" file for further analysis on abaqus. Now, im trying to import that "inp" file to abaqus but i simple can't. When i try to import to abaqus (Import- Model - inp) the program stops responding. I let it on for one...- jaulino
- Thread
- Replies: 2
- Forum: DASSAULT: ABAQUS FEA Solver
