Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Jasonmissimer
-
Center less grinding
Also I have checked and rechecked the alignment of machine numerous times- Jasonmissimer
- Post #4
- Forum: Steel and Stainless engineering
-
Center less grinding
They are only half way around the tube so maybe 1" or so long..evenly spaced apart about 1/16 of an inch..but they only appear in sections of the tube..I have removed all side guides and have taken out carbide tipped blades on the last 3 finishing heads and replaced with brass..it's hard to pin...- Jasonmissimer
- Post #3
- Forum: Steel and Stainless engineering
-
Center less grinding
Anyone have any knowledge of center less grinding out there..having a issue with "grind lines" in finished parts..grinding on a 5 head Acme abrasive belt grinder. Grinding a carbon steel tube from a 7/8 dia to a 1 1/4 dia...alignment seems to be right..good run line on carbide tipped blades..no...- Jasonmissimer
- Thread
- Replies: 4
- Forum: Steel and Stainless engineering
