Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by jamfu

  1. jamfu

    bend allowance for odd shapes

    Tick, A good rule of thumb for bend allowances on a 90 deg bend are as follows: thk<14GA BA=1.57(r+1/3t)r=male die rad thk>15Ga BA=1.57(+.4t)
See more

Part and Inventory Search

Back
Top Bottom