Dear guys,
I want to invest in a electro-magnetic FEA software,
I know Maxwell 3D, Ampere 3D, and Flux 3D, and I found on internet EMS (which is working with SolidWorks).
I'm just curious to know if it's a good product and its cost.
Does anybody knows about that software?
In advance thank you...
Hello Israelkk,
thx for your answer,
the actuator will run for a million cycles, and I would like to have about 15 mNm preload torque and after aa angle stroke of 70° the spring torque would not exceed 40 mNm.
The OD of the spring will be about 38mm and I assum that the ID will be arround 20mm...
Hello everybody,
I have to integrate a spring in an actuator, and I was thinking about a round wire spiral spring. Unfortunately I have no experience in the design of such spring.
first question: does the torque versus angle formula is linear or what is the calculation formula?
2nd: what is the...
hello diamondjim,
The hardness would be around 50HRC, I wanted to use steel but the steel-steel friction factor is about 0.1. Do you have any idea of material pair which will have a friction factor of 0.2 with lubrication
Electro-mechanical designer
Hello to everybody,
I'm looking forward materials which have a friction factor of about 0.2 (lubricated) and the higher hardness.
Does it make sense to search such marterial?
In advance thanks!
JamesXIII
Electro-mechanical designer
