Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Jamdat
-
Workbench Mechanical - contact not working
Sorry about the delay in replying, but thank you for your advice! I was able to get the simulation working well enough to be useful. I ended up using bonded contact with the circles. I'm going to experiment with contact over the next little while to try and become more proficient. Two questions...- Jamdat
- Post #4
- Forum: ANSYS: ANSYS Software Suite
-
Workbench Mechanical - contact not working
Hello all, I am working on simulating a fixture that will hold a ring for machining. Using Ansys Workbench, I've simplified my model down to 2D geometry made in design modeler, but I'm struggling to get contact working. The solution (picture attached) fails to converge and gives messages about...- Jamdat
- Thread
- Replies: 5
- Forum: ANSYS: ANSYS Software Suite
