Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Jamaureira
-
change of tension formula
studying a rolling mill model I have found this equation: dT/dt=k(V2-V1) where V1: strip velocity at point 1 V2: strip velocity at point 2 T: strip tension stress at a point between point 1 and point 2 Is that correct? What principle of physics is it based on? thanks, JAM- Jamaureira
- Thread
- Replies: 1
- Forum: Mechanical engineering general discussion
-
change of tension formula
Studying a rolling mill model I have found this equation: dT/dt=k(V2-V1) where V1: strip velocity at point 1 V2: strip velocity at point 2 T: strip tension stress at a point between point 1 and point 2 Is that correct? What principle of physics is it based on? thanks, JAM- Jamaureira
- Thread
- Replies: 0
- Forum: Gear and Pulley engineering
