Hi,
As I will work with a new client on a new project (aeronautics), I will have to use some new modules on Catia V5 R18.
One of them is called "Holes and fasteners" but I cannot find it in my Catia version (I think it is a P2 version). I'm even wondering if it is just a tool in a module...
I processed the analysis which failed because of "EXCESSIVE PIVOT RATIOS IN MATRIX KLL".
Used to that, I fixed it and processed the analysis again.
And then, in the analysis monitor, after 5 to 20 seconds I get the following :
(...)
14:31:19 Beginning analysis
14:31:19 NSINIT: *** NSINIT ERROR...
Thanks,
Just to be sure :
Where do I have to paste this ?
Do I paste even the $ ?
What do I have to change if my scratch file is in the default location ?
Regards,
Julien
Also,
If I go on working on my model, I get the following error :
Unable to allocate memory to save graphics.
Close other applications, add real or virtual memory. For animations use fewer frames or a smaller window.
The problem occurs when reaching approx. 1.5 Go of virtual memory. I...
It's not the same for every model. It happens when my model is getting too big, I think.
Could it be a problem in the compatibility with my OS ? I have got Femap Nx Nastran 9.2 and an XP SP2 64 bits 2003.
And also, what does a rebuild consist in exactly ?
Thanks,
Julien
That is true : exporting the model is working. But am I not losing data doing this ? (The model exported weights the 2/3 of my initial save ; the meshes are still there but some surfaces have vanished)
Julien
