Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by JackBarraclough

  1. JackBarraclough

    st moved from xp to new win 7 system, no improvement

    I found poor performace in V20 on my new win7 system. I found solid edge was using a backingstore rather than the 3D rendering capability of my graphics card. I went to Tools -> options -> Veiw (tab) then unchecked Automatic Selection under Application display, and changed the setting to...
  2. JackBarraclough

    Can't draw small gears

    That got it, thank you.
  3. JackBarraclough

    Can't draw small gears

    I'm having dificulty drawing up some small gears I need manufactured for a cryogenic system. I'm fairly new to solid edge and I'm using the solid edge rack and pinion designer in SE V.20, and I want to draw a module 0.5mm gear with 20 teeth, but keep getting the error "Pinion tooth is short and...
See more

Part and Inventory Search

Back
Top Bottom