Recent content by israeljrr

Are a gas separation facilities on production field, so all the pipeline are API but ISBL we will apply ASME B31.3.

Hello, Someone knows if it´s possible replace ASTM A-106 Gr. B by API 5L X-42 PSL-1, in a gas sour service. Thanks for the help.

Hello everyone, Does anyone knows if the NFPA prohibits the use of deflector cone on top of a LPG sphere? and if it's true, in which standard is mentioned. The doubt is coming because the client want use cone deflector instead a fire protection ring with sprinkler As a reference parameter...

the doubt is coming because the client want use cone deflector instead a fire protection ring with sprinkler

Hello everyone, Does anyone knows if the NFPA prohibits the use of deflector cone on top of a LPG sphere? and if it's true, in which standard is mentioned. As a reference parameter the average wind velocity it's around 1.5 m/s. Thanks

It's a new work. Regards, Israel

Thanks gr2vessels, and yes I made a mistake in the drawing, because I've tried to show that we are going to weld the pipe support to the plate. Aditionally, we will send the loads in these points for the sphere manufacturer, in order to be considered in the design of the shell. Under these...

Hi, I would like to know if it's possible weld a pipe support over a plate that is welded/attached an sphere, without lose the ASME stamp? Attached, you will find a sketch about the question previous. Thanks in advance

Thanks gr2vessels, but my primary concern it's relative with the design conditions, what do you think about the 316L plate material for that temperature, would be better than 316? or we should ask for another tipe of SS

Hi, I have a 4" line with a "Y" Strainer, the supplier is offering the mesh in ASTM A240 TP 316L, it is recomended or possible? The design conditions for the auxiliary main steam are: Pressure 162.7 barg Temperature 553 °C Thanks in advance

Hi, I'm already working in a CC power plant project (ASME B31.1) where the client establishes the percentage or range for the Non Destructive Test in valves. But now I'm wondering if these percentages or range of examination are established in a international standard? or just depend the...

Hi, Does anybody please tell me, about what international standard use for a seawater pipe system who has to be made according ASTM B43 & B61? I would like to know which ASME standard could I use to consider the fittings dimensions Thanks in advance.

Hi, I'm working in the design of a Power Generation Plant and we are in the final stage of the design. The configuration of the plant it's quite complex we have two module with a distribution of 3 (GVRC) to 1 (steam turbine). Now well, our client doesn't allows flanged conections (only buttweld...