Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by iprestes
-
NX NASTRAN Topology Optimization
0.514 mm against 0.435mm on the original design. However, I get the same problem with the material density. With a lower bound of 0.81, there is no connection between the parts; with a lower bound of 0.79, I get the same geometry as the original. With 0.8, I get a kind of a porous material, but... -
NX NASTRAN Topology Optimization
Hello, I am a new user of the Topology Optimization NX Nastran (version 12.0). I did the Siemens tutorials and tried to reproduce the same steps for another geometry that I created. However, the optimized geometry's displacement is way too high. It results in 25 mm, although I set a... -
NX NASTRAN Topology Optimization
Hello, I am a new user of the Topology Optimization NX Nastran (version 12.0). I did the Siemens tutorials and tried to reproduce the same steps for another geometry that I created. However, the optimized geometry's displacement is way too high. It results in 25 mm, although I set a constraint...- iprestes
- Thread
- Replies: 0
- Forum: Siemens: UG/NX
