Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ippy00
-
Press fit and welded members
I am researching the effects of adding a shrink fit up onto a hollow shaft. The project entails that the previous design consisted of a hub welded onto a 4" steel shaft from 2 sides. As the welds could not withstand the load, the new design was switched to a shrink fit hub with a weld on the...- Ippy00
- Thread
- Replies: 2
- Forum: Mechanical engineering general discussion
