Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ingenieur18
-
FiberSim Error
I run the producibility before trying to generate flat patterns and it works fine. I see the mesh over the part and no errors are reported. Do you know what "placement panes" are? Thanks for the reply- Ingenieur18
- Post #3
- Forum: Composite engineering
-
FiberSim Error
Hello, I am trying to generate flat pattern layouts from FiberSim 13 but I keep running into the same error: "Could not generate the flat pattern. Check the placement planes." I've tried rebuilding the model, boundaries, etc with no luck. Any suggestions? What are placement planes exactly?- Ingenieur18
- Thread
- Replies: 5
- Forum: Composite engineering
