Dear colleagues,
I have recently seen a procedure for hydro test of atmospheric vats saying that they need to be filled with water and then remain filled for 24 hours.
In my case the vessel is 90 m3 316L vessel. The vessel was designed according to AD2000 and has a design pressure of 50 mbarg...
Sorry, I forgot to mention that it won't act as a total condenser. It will condensate an additional amount of 300 kg/h of vapour (so 1000 kg/h will remain as vapor).
Dear colleagues,
I am currently working in a project which includes a decrease in the operating pressure of the stripper in the hydrobon unit (hydrotreatment of naphthas).
Due to this decrease the temperature on top of the column will decrease too and the area of the aereocondenser at the top...
Good afternoon colleagues,
I am currently designing a condenser that will complement a current aero condenser.
The new condenser is going to be an AES type with 8 passes on tubeside (cooling water), 131 tubes, H bundle layout and a 45º rotated square pattern (company standard for condensation...
Dear colleagues,
whilst designing a BEM heat exchanger for warming up natural (tube) gas with steam (shell), I came up with a tube velocity of 23,48 m/s (77 ft/s). This was obtained with a shell diameter of 10".Tube count =51 with 373 " tubes. material is carbon steel.
The density at process...
Good morning collegues,
I work in planta producing glycols. Last week my boss mentioned the possibility of producing a new grade in our products, food grade.
Could someone explain to me or lead to a resource about which are the main changes to be done in a chemical plant to be able to reach...
Good morning,
we are thinking of recovering more heat of a residue current for generating more steam.
The idea is to extend the lengths of the tubes of a shell and tube heat exchanger whils keeping the current diameter.
At the moment we basically heat a boilerfeedwater current and just produce...
Good morning colleagues,
Whilst specifying the design temperature for a pipe is quite straightforward, the maximum temperatura that can reach the fluid that flows across a certain pipe, I am not so sure when it comes to the design temperature on the tube side oh a shell and tube heatexchanger...
Dear colleagues,
We are designing a 8" pipe that needs to be steam traced (low pressure steam 4 barg). The specification of the pipe is ASTM A-312 Type 304 (stainless steel).
According to the customer specification all the tracing tubes should be done in 1/2" 150# carbon steel (ASTM A-53 Gr.B...
iainuts,
Thank you for your answer. I have already a got adossier with the velocity impingment curves but there are no recommendations for the materials for internals, gaskets,etc..
Thanks you for your answer, I forgot to mention the temperature of the oxygen flow which will be 25 C. The flow will be pure oxygen.
I have already specified that the equipment will be used for oxygen service but I will be insterested in knowing some details about the kind of materials they...
Dear colleagues,
I am designing a new 3" pipe for oxygen service. The pressure at the inlet will be 7 barg (101 psig). At the end of the line will be a pressure control valve, followed by an orifice plate and a flow control valve.
The material for the line will be seamless steel ASTM A-312 Tp...
Thank very much for the explanation.
As Chedarcaveman says it is a pity that no pictures can be attached. A picture would probably make the explanation a lot easier.
Thanks
Hello,
I came across the word Cutwater today and I have never seen before talking about pumps. (I think it's like an american word)The meaning is not very clear to me. Could someone just explian what is the cutwater?
Thank you
