Kenja,
Did you ever find a solution to this? While John's suggestion is one solution, we prefer to have our drawings saved as sheets in our top level assembly file and not create new components for every burn location. My particular scenario involves two sets of drafting preferences (one for...
Thanks for the replies. I am going to check into the Electrode Module, it may be an answer.
Tingsryd, that is kind of how we are currently creating burn locations, except we only have one burn per sheet to avoid confusion. I was kind of hoping to be able to export something similar to a hole...
Hello,
I'm wondering if NX has a tool for outputting EDM setup (burn) sheets? I hate to reference another software; however, at 8:50 you can see roughly what I'm looking for ( https://www.youtube.com/watch?v=sxjxqZwuB5E#t=519 )
At the very least, I'm looking for what I would call a coordinate...
As long as I've been using the mirror assembly command, I've had a problem in which the solution that appears to be correct is actually out of position by .1 Degrees(ish). When I have noticed this and attempted to find a solution that is correct, generally this is the only option which is...
Kasey,
I just submitted this same issue to GTAC on a file that was created in 7.5.2.5 and will not open in 7.5.3.3. The same file will open on an identical machine running 7.5.2.5 without incident. I suspect that the problem is in 7.5.3.3 and I'll let you know what I find out.
~Kevin
