Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ICanBreakIt

  1. ICanBreakIt

    Corner Radii vs Notch Factor

    We are appling forces to our model. I will check and see if we have refined the mesh in the higher stress areas. Thanks
  2. ICanBreakIt

    Corner Radii vs Notch Factor

    We have been working on a part that is shaped like a horse shoe with machined bosses on the ends. Where the bosses connect to the horse shoe we have a generous 3/16 radius. When we run the fea we are getting very high stress concentrations on the corner radii. When we modify the model and reduce...
See more

Part and Inventory Search

Back
Top Bottom