Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ian99rt

  1. ian99rt

    from an Asm need to create Datum curves from an Xsec

    I'm guessing this is the same question i have. I have a splined shaft that I need to make a cut of the same splined cross section. Is this the same process I want to take?
See more

Part and Inventory Search

Back
Top Bottom