Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by hyphyengineer
-
GD&T of CFR
I tried posting earlier but I don't think it went through. Sorry if this double posted. I am trying to tolerance a drawing for carbon fiber calibration targets. The material is very textured, think small diamond plate. If I put a flatness tolerance of .0002" on it will all the parts fail...- hyphyengineer
- Thread
- Replies: 1
- Forum: Drafting Standards, GD&T & Tolerance Analysis
