Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by HvanBaal

  1. HvanBaal

    Length of neutral line after bending sheet metal

    Hello, I'm looking for the right calculation method for calculating the length of the neutral line of a piece of sheet metal after bending it into a tube. We use 304 and 316L stainless steel. I know it depents on a lot of properties (type, temp, etc). I'm looking for a methode that is as...
See more

Part and Inventory Search

Back
Top Bottom