Thanks for your help.
Currently my workaround is:
(1) do a STEP-Import batch conversion using a Daimler-model-part (substituting "step214ugnullnx90_mm.prt")
(2) do a STEP-Import batch conversion using a Daimler-assembly-part (substituting "step214ugnullnx90_mm.prt")
(3) merging both results...
Hello everybody,
unfortunately no new postings here.... :-(
In my case the main problem is that the STEP converter uses the standard model “step214ugnullnx90_mm.prt” (from the STEP214UG directory)
for creating part-prts AND assembly-prts......(which is surprising for a CATIA user that an...
Hi Xwheelguy, thanks for your reply.
I think for single part conversion your suggestion should work.
My problem is that I need to convert a large assembly (in batch mode) with lots of parts and sub-assemblies using the STEP converter batch
and therefore need a way to define my required start...
Hallo everybody,
I am trying to convert a large (CATIA) assembly to NX via STEP214 interface.
My problem is that I need a specific start model in NX, a Daimler conform model.
Is it possible to configure the NX STEP214 converter properly to use a specific start model?
E.g. using the definition...
