Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Huhu3
-
NX 11: Snapping to angled holes on a pipe
Hi, I would like to know if there is a smart way to snap to angled holes on a pipe? I have found a way to work around this by adding points in the right coordinates but if the positions of the holes are changed, the section line will not be updated. Best regards, Huhu...- Huhu3
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
