Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by hts

  1. hts

    next Compress release

    Just wondering what kind of changes / upgrades that are being planned for the next Compress release??
  2. hts

    ASME VIII-1 App. 1-10 Large Openings

    As a note to other designer's, the TSSA (Ontario) requires that Appendix 1-10 calculations also meet the requirements of UG-36(b)(1). At this time, they do not accept that this is an alternate method. Compress does not follow this ruling. To resolve this issue, I would suggest using the App...
  3. hts

    Lifting lug design to BTH-1

    A Client is now mandating that lifting lugs on their pressure vessels be designed to ASME BTH-1 (Design of Below-the-Hook Lifting Devices). Codeware's Compress software designs lugs for the BTH-1 allowable stresses, but this isn't acceptable. In addition, they require the lug to be designed...
  4. hts

    Latest Update 6253 margins all screwed up for printing

    No only does it affect printing in Compress, it also affects printing from Microsoft Outlook and Internet Explorer. There are no margins there either unless you use Page Setup and readjust margins. Lorne
  5. hts

    Opening in API tank wall for equipment access

    A contractor wants to be able to cut a door sheet opening in an existing out of service domed roof API tank to get equipment inside to scrape out sludge, etc. What reinforcing needs to be installed around the proposed opening to make tank safe (opening to be 12 foot square in a 126' diameter x...
See more

Part and Inventory Search

Back
Top