Hi Kenat,
This makes sense :-)
Maybe you just have to start out right from the beginning...
I have created a drawing with relationships that cannot be edited because they would break.
Thanks for the responses,
Best regards,
Howerd
Hi Kenat,
There are loads of tutorials, and I have read as many as I can find.
I have turned on "Maintain Relationships", and "Relationship Handles" display.
The dimensions I have are green, so driven. If I edit these they are flagged as "Not to scale" and are underlined - this is not what I...
Hi Kenat,
I am using Solid Edge 2D Drafting ST5 2012, downloaded from Siemens last week.
> So it kind of sounds like you're perhaps doing something wrong
Yep ;-)
Maybe you could tell me how to adjust a dimension value, from say 50.0005 to 50.0000, without dragging the line manually?
Also...
Hi,
I have just used Solid Edge for the first time, and I have entered a simple drawing to have some holes drilled in an enclosure.
I found it very difficult to get the dimensions right - I would like every length to be a whole number of mm.
The drawing now has dimensions resolved down to...
