Hi,everyone:
I am a little puzzled with the coincidence question of the geometry-mesh for one part of the whole model. I can try two approaches:
(1) Apply loads on the area in Hypermesh. The loads can be applied on the geometry directly in Hm and the loads can be imported into Ansys. However...
Thank you very much.
I know the load can be transfered easily from geometry to elements (or nodes) if geometry and mesh is connective.
So I want to associate geometry and mesh of the model in ANSYS, but how to do it? Because meshing file (prp) is obtained from Hypermesh, and geometry file (igs)...
Hi, crazyfan
Thank you for your recommendation. I am sorry I don't know the keywords of "sftran" and "dtran". Could you explain it in detail?
Thanks and regards.
The meshing file obtained from Hypermesh is imported in Ansys. Due to appling load on the areas is more convenient than on the elements for the analysis, the geometry file (igs) is imported in Ansys as well.
Now my qustions is how to build geometry-mesh associativity so that the load on the...
While performing thermal-stress analysis, error messages appeared: "runtime error! program: e:\ansys\bin\intel\ansys.exe abnormal program termination".
The mesh has no error, and the problem consists of 800,000 DOFs.
Thanks in advance.
