Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by holemaker888
-
Hole angularity mismatch
We are talking about DA holes here. I guess that it is important that temperary fastener could go through and hold the two pieces together. At the same time, we could not oversize the hole diameter too much which could cost the lost of the positional accuracy. By considering the two factor, you...- holemaker888
- Post #11
- Forum: Aircraft engineering
